UNPACKING AND ASSEMBLY
1 – Remove the oven packaging.
Simply remove the plastic straps (A) and lift off the top cap (C).
2 – Empty the combustion chamber
by removing the oven parts and documentation from inside the chamber.
3 – Remove the laser protective film from all stainless steel parts
Such as: sill, door, flue and chimney. Use a hair dryer to speed up the procedure and easily remove the laser film.
4 – Install the 4 feet.
Install the feet by screwing them into the special housings in the lower part of the oven.
5 – Insert the supplied battery into the igniter.
Unscrew the igniter button, insert the battery (E), then screw back the ignition button. Now when pressing the button you will see and hear a small spark.
• Check the indicated polarity.
• Battery type: AA supplied
6 – Install the flue and chimney.
Insert the flue (F) in the appropriate housing (flange) and then insert the chimney (G).
7 – Assemble the door.
It will be sufficient to screw the black duroplast handle (H) locking it with the appropriate bolt contained in the packaging.
When you unbox the oven for the first time, due to shipping, you may notice the presence of red refractory powder on the cooking floor. If this is the case, you should brush the powder off. We also recommend to cook and discard 2 or 3 pizza dough balls to ensure you remove the refractory powder before cooking and eating your first pizza. If your are using the oven for the first time or after a prolonged period of inactivity we recommend to extend your pre-heating of the oven by an extra 30 minutes to allow the dispersion of any humidity possibly collected by the refractory bricks during shipping or after prolonged inactivity.
POSITIONING
View from above
ATTENTION
The outer sides of the oven can reach temperatures above 80°C (176°F). Any flammable materials must not be within 1-metre (39 in) radius of the oven.
CAUTION: When being used, place the oven at a safe minimum distance from flammable materials or any other substance that can be damaged by heat.
CAUTION
Put the oven away from wind or strong drafts.
FOR YOUR SAFETY
Place the oven on a flat and stable surface. Involuntary movements during operation may result in personal injury and property damage.
CAUTION: Place the oven at a minimum distance of 20 cm (8 in) from the wall or any other equipment. Increase the minimum distance to 50 cm (20 in) around the flue and 1m from the top of the oven.
THE OVEN SHOULD BE PLACED ON TABLES, BASES OR
OTHER FIREPROOF SURFACES WITH ENOUGH LOAD-BEARING CAPACITY (for the weight, refer to the product data sheet attached to the instruction manual), ADJUST THE LEVELLING FEET TO HOLD THE OVEN STEADY.
For under-roof installations, click here
